International Chemical Safety Cards

LEAD TETROXIDE ICSC: 1002

Lead orthoplumbate
Red lead
Minium
C.I. Pigment Red 105
Pb3O4
Molecular mass: 685.6
ICSC #    1002
CAS #     1314-41-6
RTECS # OG5425000
EC #         082-001-00-6
October 15, 2001 Peer reviewed
TYPES OF HAZARD/ EXPOSURE ACUTE HAZARDS/ SYMPTOMS PREVENTION FIRST AID/
FIRE FIGHTING
FIRE Gives off irritating or toxic fumes (or gases) in a fire. Many reactions may cause fire or explosion.
NO contact with reducing agents.
In case of fire in the surroundings: water spray.
EXPLOSION


EXPOSURE
AVOID EXPOSURE OF (PREGNANT) WOMEN!

 •INHALATION
Local exhaust or breathing protection.
Fresh air, rest.
 •SKIN
Protective gloves.
Remove contaminated clothes. Rinse and then wash skin with water and soap.
 •EYES
Safety spectacles.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then take to a doctor.
 •INGESTION Abdominal pain. Nausea. Vomiting.
Do not eat, drink, or smoke during work. Wash hands before eating.
Rinse mouth. Give plenty of water to drink. Refer for medical attention.
SPILLAGE DISPOSAL STORAGE PACKAGING & LABELLING
Sweep spilled substance into containers; if appropriate, moisten first to prevent dusting. Carefully collect remainder, then remove to safe place. Do NOT let this chemical enter the environment. Personal protection: P3 filter respirator for toxic particles.
Separated from food and feedstuffs and strong reducing agents. See Chemical Dangers.

T symbol
N symbol
R: 61-20/22-33-62-50/53
S: 53-45-60-61
SEE IMPORTANT INFORMATION ON BACK
ICSC: 1002 Prepared in the context of cooperation between the International Programme on Chemical Safety & the Commission of the European Communities (C) IPCS CEC 1994. No modifications to the International version have been made except to add the OSHA PELs, NIOSH RELs and NIOSH IDLH values.

International Chemical Safety Cards

LEAD TETROXIDE ICSC: 1002
I

M

P

O

R

T

A

N

T


D

A

T

A
PHYSICAL STATE; APPEARANCE:
RED CRYSTALS OR POWDER.

PHYSICAL DANGERS:


CHEMICAL DANGERS:
The substance decomposes on heating producing oxygen and toxic fumes. Reacts violently with reducing agents causing fire hazard.

OCCUPATIONAL EXPOSURE LIMITS:
TLV: (as Pb) 0.05 mg/m³ as TWA; A3 (confirmed animal carcinogen with unknown relevance to humans); BEI issued; (ACGIH 2004).
MAK: (as Pb) (Inhalable fraction);
Carcinogen category: 3B; Germ cell mutagen group: 3A;
(DFG 2004).


ROUTES OF EXPOSURE:
The substance can be absorbed into the body by inhalation and by ingestion.

INHALATION RISK:
Evaporation at 20°C is negligible; a harmful concentration of airborne particles can, however, be reached quickly when dispersed, especially if powdered.

EFFECTS OF SHORT-TERM EXPOSURE:


EFFECTS OF LONG-TERM OR REPEATED EXPOSURE:
The substance may have effects on the blood , bone marrow , central nervous system , peripheral nervous system and kidneys , resulting in anaemia, encephalopathy (e.g., convulsions), peripheral nerve disease, abdominal cramps and kidney impairment. Causes toxicity to human reproduction or development.
PHYSICAL
PROPERTIES
Melting point (decomposes): 500°C
Density: 9.1
g/cm3
Solubility in water: none
ENVIRONMENTAL
DATA
Bioaccumulation of this chemical may occur in plants and in mammals. It is strongly advised that this substance does not enter the environment.
N O T E S
Depending on the degree of exposure, periodic medical examination is suggested. Do NOT take working clothes home. Card has been partly updated in April 2005. See section Occupational Exposure Limits.
ADDITIONAL INFORMATION


ICSC: 1002 LEAD TETROXIDE
(C) IPCS, CEC, 1994
IMPORTANT LEGAL NOTICE: Neither NIOSH, the CEC or the IPCS nor any person acting on behalf of NIOSH, the CEC or the IPCS is responsible for the use which might be made of this information. This card contains the collective views of the IPCS Peer Review Committee and may not reflect in all cases all the detailed requirements included in national legislation on the subject. The user should verify compliance of the cards with the relevant legislation in the country of use. The only modifications made to produce the U.S. version is inclusion of the OSHA PELs, NIOSH RELs and NIOSH IDLH values.