International Chemical Safety Cards

PINDONE ICSC: 1515

2-Pivaloylindan-1,3-dione
2-(2,2-Dimethyl-1-oxopropyl)-1H-indene-1,3 (2H)-dione
2-Pivaloyl-1,3-indandione
C14H14O3
Molecular mass: 230.3
ICSC #    1515
CAS #     83-26-1
RTECS # NK6300000
UN #        2588
EC #         606-016-00-X
April 22, 2004 Peer reviewed
TYPES OF HAZARD/ EXPOSURE ACUTE HAZARDS/ SYMPTOMS PREVENTION FIRST AID/
FIRE FIGHTING
FIRE Combustible.
NO open flames.
Powder, water spray, foam, carbon dioxide .
EXPLOSION


EXPOSURE
STRICT HYGIENE!

 •INHALATION
Local exhaust or breathing protection.
Fresh air, rest.
 •SKIN
Protective gloves.
Remove contaminated clothes. Rinse and then wash skin with water and soap.
 •EYES
Safety spectacles.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then take to a doctor.
 •INGESTION Symptoms will likely be caused by bleeding and will depend on the affected organ.
Do not eat, drink, or smoke during work. Wash hands before eating.
Give a slurry of activated charcoal in water to drink. Refer for medical attention.
SPILLAGE DISPOSAL STORAGE PACKAGING & LABELLING
Sweep spilled substance into containers; if appropriate, moisten first to prevent dusting. Do NOT let this chemical enter the environment. Personal protection: P3 filter respirator for toxic particles.
Separated from food and feedstuffs.
Do not transport with food and feedstuffs.
Marine pollutant.
T symbol
N symbol
R: 25-48/25-50/53
S: 1/2-37-45-60-61
UN Hazard Class: 6.1
UN Packing Group: III
SEE IMPORTANT INFORMATION ON BACK
ICSC: 1515 Prepared in the context of cooperation between the International Programme on Chemical Safety & the Commission of the European Communities (C) IPCS CEC 1994. No modifications to the International version have been made except to add the OSHA PELs, NIOSH RELs and NIOSH IDLH values.

International Chemical Safety Cards

PINDONE ICSC: 1515
I

M

P

O

R

T

A

N

T


D

A

T

A
PHYSICAL STATE; APPEARANCE:
YELLOW CRYSTALS .

PHYSICAL DANGERS:


CHEMICAL DANGERS:


OCCUPATIONAL EXPOSURE LIMITS:
TLV: 0.1 mg/m³ as TWA; (ACGIH 2004).


ROUTES OF EXPOSURE:
The substance can be absorbed into the body by ingestion.

INHALATION RISK:
Evaporation at 20°C is negligible; a harmful concentration of airborne particles can, however, be reached quickly especially if powdered.

EFFECTS OF SHORT-TERM EXPOSURE:
The substance may cause effects on the blood , resulting in haemorrhage. The effects may be delayed. Medical observation is indicated.

EFFECTS OF LONG-TERM OR REPEATED EXPOSURE:
PHYSICAL
PROPERTIES
Decomposes below boiling point
Melting point: 108-110°C
Density: 1.06
g/cm3
Solubility in water, g/100 ml at 25°C: none
Vapour pressure, Pa at 25°C: negligible
ENVIRONMENTAL
DATA
The substance is very toxic to aquatic organisms. This substance may be hazardous in the environment; special attention should be given to birds and mammals. This substance does enter the environment under normal use. Great care, however, should be given to avoid any additional release, e.g. through inappropriate disposal.
N O T E S
Temperature of decomposition unknown in literature. Depending on the degree of exposure, periodic medical examination is suggested. The symptoms of bleeding do not become manifest until a few hours or even a few days have passed. Specific treatment is necessary in case of poisoning with this substance; the appropriate means with instructions must be available.
Transport Emergency Card: TEC (R)-61GT7-III
ADDITIONAL INFORMATION


ICSC: 1515 PINDONE
(C) IPCS, CEC, 1994
IMPORTANT LEGAL NOTICE: Neither NIOSH, the CEC or the IPCS nor any person acting on behalf of NIOSH, the CEC or the IPCS is responsible for the use which might be made of this information. This card contains the collective views of the IPCS Peer Review Committee and may not reflect in all cases all the detailed requirements included in national legislation on the subject. The user should verify compliance of the cards with the relevant legislation in the country of use. The only modifications made to produce the U.S. version is inclusion of the OSHA PELs, NIOSH RELs and NIOSH IDLH values.